Automotive
There is one problem that is often experienced by motorists. Ie: the engine is not strong at-starter. When the ignition key in START `position`, the machine would not turn. Only the sound of `tek ... `tek. As a result, the car was not able to walk.
Based on data from Emergency Roadside Assistance (ERA) AstraWorld, this is indeed the most frequent problems arise. `On average, every month, 30 percent of one thousand units over the ERA is handled this problem,` said Suwarno, Technical and Training Development staff ERA AstraWorld.
Machines that are not strong starter may occur due to battery or battery not save stun or electric current. Why no stun? Typically, the main cause is lack of water stun empty battery. That is, the amount or quantity of battery acid is not as it should be: not a line between low-level and upper level usually indicated on the battery box.
Properly controlled quantity of battery acid. When positioned immediately below the low-level add. Because, battery acid works to help cool the battery cells. Tasks that make battery acid is reduced (evaporates when absorbing heat).
Well, if the water is reduced and the battery is not immediately added, would make the cells inside the curved battery - should these cells are parallel and perpendicular. The curvature of these cells can make a positive and negative plates in contact, which ultimately makes surge. Surge that makes the battery is not able to save the stun.
The other side to check is the battery terminals. Check whether there is corrosion or not. See also wires the positive and negative. Maybe lax or loose. Corrosion and loose wires to make a weak electric current conductivity. Thus, the current flowing to the starter motor is small and not strong enough to rotate the engine.
If the battery water is replenished, corrosion cleaned and tightened the cable but still did not want to be a starter, try the battery jumper ``, or `fished`. You do this by connecting the car battery is not strong starter with another car. Of course, battery capacity must match the two cars. Maybe it's a bit difficult to do because in addition to need another car, also need to jumper cables.
Especially for a car with gears (transmission) manual no alternative. You can trigger the spin machine to propel the vehicle. Try to turn the ignition on position `ON`. Enter the second gear, then stepped on the clutch pedal, then push the car. Once the car reaches a speed of rotation of the tire enough, lepaslah clutch pedal. Properly, so the pedal is released, the engine to life. This too may be a bit difficult because it takes help from others.
If the steps above have been done but the problem remains unsolved, you need not worry. `Call it AstraWorld ERA. Service Agent we will immediately go to the place you're having trouble, 'said Suwarno.
To prevent the engine starter is not strong, according to Suwarno, do routine maintenance on your vehicle battery. As already described above, there are some things that need to be done:
Check the battery water periodically.
Check the battery terminals.
Check the battery cables.
translate fr (astraworld)
for more details and updates about automotive-technology-guide please visit.........
www.automotive-technology-guide.com
---or---
